VTech LS6217 User Manual page 52

Appendix
CONNECTING... shows in the handset screen.
• The handset might be out of range. M
base.
• Make sure the power cord is securely plugged into the telephone
base. Use a working electrical outlet not controlled by a wall switch.
• Reset your telephone by unplugging the power adapter from the
telephone base. Disconnect the battery from the cordless handset.
Wait for 15 seconds, then plug in the power adapter and re-install the
battery. Place the handset in the telephone base and allow up to one
minute for the handset and telephone base to synchronize.
• Other electronic products might prevent your handset and telephone
base from communicating with each other. Install your telephone
base as far away from these electronic devices as possible: wireless
routers, radios, cellular telephones, intercoms, room monitors,
televisions, personal computers, kitchen appliances and other
cordless telephones.
Common cures for electronic equipment.
• If the telephone is not responding normally, put the cordless handset
in the telephone base. If it does not respond, try the following (in the
order listed):
1. Disconnect the power to the telephone base.
2. Disconnect the battery on the cordless handset.
3. Wait a few minutes before connecting power to the telephone
base.
4. Re-install the battery and place the cordless handset in the
telephone base or charger.
5. Wait for the cordless handset to synchronize with the telephone
base. Allow up to one minute for this to take place.
ve it closer to the telephone
O
48