Telephone Base Installation - VTech LS6217 User Manual

Getting started

Telephone base installation

If you subscribe to digital subscriber line (DSL) high-speed Internet
service through your telephone line, you must install a DSL filter
between the telephone line cord and the telephone wall jack. The filter
prevents noise and caller ID problems caused by DSL interference.
Contact your DSL service provider for more information about DSL
filters.
Install the telephone base as shown below:
4. Plug the other end of
the telephone line cord
into a telephone wall
jack.
If you have DSL high-
speed Internet service, a
DSL filter (not included) is
required.
1. Plug one end of the
telephone line cord
into the telephone
jack on the back of the
telephone base.
• Use only the power adapter supplied with this product. To order
a replacement, visit our website at www.vtechphones.com or
call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com
or call 1 (800) 267-7377.
• The power adapter is intended to be correctly oriented in a
vertical or floor mount position. The prongs are not designed to
hold the plug in place if it is plugged into a ceiling or an under-
the-table/cabinet outlet.
6
3. Plug the large end of
the power adapter into
an electrical outlet not
controlled by a wall
switch.
2. Plug the small end of
the power adapter into
the power jack on the
back of the telephone
base. Route the power
cord through the slot.