Belkin F6D4230-4 User Manual page 87

20929_8820-00034_F6D4230-4_Enhanced_Router_User_Manual_111008 clean.doc
Page 87 of 114
3. Select "Built-in Ethernet" (1) next to "Show" in the Network menu.
(1)
(2)
(3)
[keep]
4. Select the "TCP/IP" tab (2). Next to "Configure" (3), you should see
"Manually" or "Using DHCP". If you do not, check the PPPoE tab (4) to make
sure that "Connect using PPPoE" is NOT selected. If it is, you will need to
configure your Router for a PPPoE connection type using your user name
and password.
5. If "Manually" is selected, your Router will need to be set up for a static IP
connection type. Write the address information in the table below. You will
need to enter this information into the Router.
[MacOS9 chart.tif]
6. If not already selected, select "Using DHCP" next to "Configure" (3), then click
"Apply Now".
Your network settings are now configured for use with the Router.
[use current image]
(4)
[xxxxxxx] [use current image]
[keep]