Screw Terminal Connector Plugs; Cables And Accessories - National Instruments USB-6008 User Manual

LED State
Not lit Device not connected or in suspend
On, not blinking Device connected but not initialized, or the computer is in standby mode.
In order for the device to be recognized, the device must be connected to a
computer that has NI-DAQmx installed on it.
Single-blink Operating normally

Screw Terminal Connector Plugs

The NI USB-6008/6009 ships with one detachable screw terminal connector plug for analog
signals and one detachable screw terminal connector plug for digital signals. These screw
terminal connectors provide 16 connections that use 16 AWG to 28 AWG wire. Refer to step 4
of the Setting Up the NI USB-6008/6009
screw terminal connector plugs. Refer to the
device pinout and signal descriptions.
You can order additional connectors and labels for your device. Refer to the
Accessories section for ordering information.
Firmware
The firmware on the NI USB-6008/6009 refreshes whenever the device is connected to a
computer with NI-DAQmx. NI-DAQmx automatically uploads the compatible firmware
version to the device. The firmware version may be upgraded when new versions of
NI-DAQmx release.

Cables and Accessories

The following table contains information about cables and accessories available for the
NI USB-6008/6009. For a complete list of accessories and ordering information, refer to the
pricing section of the NI USB-6008 or NI USB-6009 product page at
8 | ni.com | NI USB-6008/6009 User Guide
Table 3. LED State/Device Status
section for information about selecting labels for the
Pinout and Signal Descriptions
Device Status
section for the
Cables and
.
ni.com