Led Indicator; Screw Terminal Connector Plugs; Cables And Accessories - National Instruments USB-6001 User Manual

LED Indicator

The NI DAQ device has a blue LED that indicates device status, as listed in Table 3.
LED State
Off
On, not blinking
Blinking

Screw Terminal Connector Plugs

The NI USB-6001/6002/6003 ships with two detachable screw terminal connector plugs: one for
analog signals and one for digital signals. These screw terminal connectors provide
16 connections that use 0.08 to 1.31 mm
Descriptions section for the device pinout and signal descriptions.

Cables and Accessories

Table 4 contains information about cables and accessories available for the
NI USB-6001/6002/6003. For a complete list of accessories and ordering information, refer to
the pricing section of the NI DAQ device product page at
Table 4. NI USB-6001/6002/6003 Cables and Accessories
Accessory
USB-600x Accessories
USB-600x Series
Prototyping Accessories
Hi-Speed Micro USB
Cable, A to Micro-B
Caution: To ensure the specified EMC performance, the length of any wire or cable
connected to the screw terminal connector must be no longer than 0.5 m (20 in.).
8 | ni.com | NI USB-6001/6002/6003 User Guide
Table 3. LED State/Device Status
Device is not connected or is in suspend mode.
Device is connected and functioning normally.
Device has encountered an error. Wait 10 seconds to allow the
device to attempt to recover from the error. If the LED
continues blinking, disconnect and reconnect the device. If
the error persists, contact National Instruments. Refer to the
Worldwide Support and Services
information.
2
(28 to 16 AWG). Refer to the
Part Number
782703-01
779511-01
782909-01,
782909-02
Device Status
section for contact
.
ni.com
Description
Four additional screw-terminal connectors
and a screwdriver.
Unshielded breadboarding accessory for
custom-defined signal conditioning and
prototyping. You can use up to
two accessories per device.
1 m and 2 m lengths
Pinout and Signal