Information - Honeywell Searchpoint Optima Plus Operating Instructions Manual

MAN0905_Issue 7_07/17 Searchpoint Optima Plus with optional HART output
®
Operating Instructions
2108M0550
1. Safety Warnings and Information

1.4 Information

This manual is for use with Searchpoint Optima Plus, Searchpoint Optima Plus XTC, Searchpoint Optima
X and Searchpoint Optima Z units of mod state 9 and above. For Searchpoint Optima X and Searchpoint
Optima Z please also refer to the supplementary information sent with the product.
Honeywell Analytics can take no responsibility for installation and/or use of its equipment if not done in
accordance with the appropriate issue and/or amendment of the Operating Manual.
The reader of this Operating Manual should ensure that it is appropriate in all details for the exact
equipment to be installed and/or operated. If in doubt, contact Honeywell Analytics for advice.
The following types of notices are used throughout this Operating Manual:
WARNING
Identifies a hazardous or unsafe practice which could result in severe injury or death to personnel.
Caution: Identifies a hazardous or unsafe practice which could result in minor injury to personnel, or
product or property damage.
Note: Identifies useful/additional information.
Every effort has been made to ensure the accuracy of this document, however, Honeywell Analytics can
assume no responsibility for any errors or omissions in this document or their consequences.
Honeywell Analytics would greatly appreciate being informed of any errors or omissions that may be found
in the content of this document.
For information not covered in this document, or if there is a requirement to send comments/corrections
about this document, please contact Honeywell Analytics using the contact details given on the back page.
Honeywell Analytics reserve the right to change or revise the information supplied in this document
without notice and without obligation to notify any person or organization of such revision or change.
If information is required that does not appear in this document, contact the local distributor/agent
or Honeywell Analytics.
10