Starting The Web Interface; Figure 10. Configuring An Snmp V3 User Profile - D-Link DES-3226L User Manual

Layer 2 switch

Hide thumbs Also See for DES-3226L:

Table of Contents

Starting the Web Interface

Follow these steps to start the switch DES-3226L Web interface:

Enter the IP address of the switch in the Web browser address field.

When the Login panel is displayed, click Login, then enter the appropriate User Name and Pass-

word. The User Name and associated Password are the same as those used for the terminal inter-

face. Click on the Login button. The System Description Menu displays as shown in Figure 9, with

the navigation tree appearing to the left of the screen.

Make a selection by clicking on the appropriate item in the navigation tree.

Configuring an SNMP V3 User Profile

Configuring an SNMP V3 user profile is a part of user configuration. Any user can connect to

the D-Link DES-3226L switch using the SNMPv3 protocol, but for authentication and

encryption, additional steps are needed. Use the following steps to configure an SNMP V3

new user profile.

Select System>Configuration>User Accounts from the hierarchical tree on the left side of the

web interface (see Figure 10).

Using the User pulldown menu, select Create to create a new user.

Enter a new user name in the User Name field.

Enter a new user password in the Password field and then retype it in the Confirm Password field.

Using the Web Interface

Table of Contents