Starting And Configuring The Switch; Configuring For In-Band Connectivity; Figure 5. Installing The Des-3226L In A Rack - D-Link DES-3226L User Manual

Figure 5. Installing the DES-3226L in a Rack

Note: This figure is not an actual DES-3226L. It is used for explanatory purposes only.
5. Secure the switch to the rack with either the rack bolts or cage nuts and cage nut bolts with washers
(depending on the kind of rack you have). Fasten the bolts on bottom before fastening the bolts on
top. Make sure that the ventilation holes are not obstructed.

Starting and Configuring the Switch

After completing all external connections, connect a terminal to a switch to configure the
switch. Additional advanced functions are described in the DES-3226L CLI Guide or check
the D-Link Support web site at
documentation and software.
NOTE:
NOTE:

Configuring for In-band Connectivity

In-band connectivity allows you to access the D-Link DES-3226L from a remote workstation
using the Ethernet network. To use in-band connectivity, you must configure the DES-3226L
with IP information (IP address, subnet mask, and default gateway).
Configure for In-band connectivity using one of the following methods:
BootP or DHCP
RS-232 port
http://support.dlink.com/
Read the release notes for this product before proceeding. You can download the
release notes from the D-Link Support website at
http://support.dlink.com/.
We recommend that you obtain the most recent version of the user documentation
from the D-Link Support website at http://support.dlink.com/.
Installing the Hardware
for the latest updates on
23