Configuring The Switch - D-Link DGS-1248T Quick Installation Manual

web_management_utility and execute the Web Management
utility. (Figure 1.)

Configuring the Switch

The DGS-1248T has a Web GUI interface for smart switch configuration.
The Switch can be configured through the Web browser. A network
administrator can manage, control, and monitor the switch from the local
LAN. This section indicates how to configure the Switch to enable its
smart functions.
Use Internet Explorer 5.0 or above Web browser.
Login
Before you configure this device, note that when the Web Smart Switch
is configured through an Ethernet connection, make sure the manager
PC must be set on the same IP network. For example, when the default
network address of the default IP address of the Web Smart Switch is
192.168.0.1, then the manager PC should be set at 192.168.0.x (where
x is a number between 2 and 254), and the default subnet mask is
255.255.255.0.
Enter IP address http://192.168.0.1 (the factory-default IP address
setting) to the address location. (Figure 2.)
Figure 1. Web Management Utility
Figure 2.
6