Toshiba RAV-GM1101AT8P-E Service Manual page 70

No. Part name
P.C.board
4
1. Detachment
(for
1) Carry out work of 4.
compressor
drive)
Never disassemble the inverter for 3
MCC-1627
minutes after power has been turned off
because an electric shock may be caused.
2) Remove the connectors and fast-on
3) Remove 1 screw for fixing the terminals
4) Remove 2 screws for fixing P.C.board
5) Remove 2 screws and take off the cover
6) Remove all the 4 screws which secures
7) Cut 2 banding bands and remove 2
8) Remove the P.C.board from the 3 PCB
9) Remove all the connectors and faston
2. Attachment
1) Mount the individual components in
Be sure that all the connectors are
connected correctly and securely inserted.
If the components on the P.C.board were
bent during this procedure, straighten
them so they do not touch other parts.
Procedure
WARNING
terminals
∗ Remove the connectors by pulling the
connector body. Do not pull the wire.
∗ Connectors should be removed after
unlocking the housing section.
Remove 10 fast-on terminals from 2
terminals and screw for fixing earth wires.
Cut the banding band and remove
connector.
CN502 : Relay input (2P: White)
CN851 : UART Communication (6P:
Red)
assembly and take off the terminals
assembly from inverter assembly with
getting off the hook of inverter assembly
from slit of the terminals assembly.
(MCC-1626) assembly and take off
P.C.board (MCC-1626) assembly.
of inverter box.
the P.C.board MCC1627 to the heat
sink.
faston terminals from PTC thermistor.
∗ Remove the connectors by pulling the
connector body. Do not pull the wire.
Mounts.
terminals connected to the P.C.board.
∗ Remove the connectors and faston
terminals by pulling the connector
body. Do not pull the wire.
∗ Connectors should be removed after
unlocking the housing section.
CN11 : Relay intput (2P: White)
CN852 : UART Communication (6P:
Red)
CN07,08 : Reactor (1P: faston
terminal)
CN200,201,202: Compressor (1P: faston
terminal)
the opposite procedure to that during
detachment.
CAUTION
P.C.board (MCC-1626) assembly
2 screw for P.C.board (MCC-1626) assembly
Screw for terminals assembly
4 screws for P.C.board (MCC-1627)
- 70 -
FILE NO.SVM-18044-2
Remarks
P.C.board (MCC-1626)
banding band
CN851 CN502
Screw for earth wires
10 faston terminals
2 screw for cover of inverter box
Cover of inverter box
2 faston terminals
3 PCB Mounts
2 banding bands