Lock /Child Safety Device; Safety Switch-Off; Other Functions; Protection Against Overheating - Smeg SE2732ID Instructions For Fitting And Use

Operations
1.
2.
Power
setting
1 to 4
5 to 7
8 or 9
18
Automatic switch-off
after ...
8 hours
2 hours
1 hour

Lock /child safety device

The lock can be used to block operation and settings (e.g. power setting 4).
An activated lock will remain activated even if the hob is switched off!
The lock hence also serves as a child safety device in order to prevent the
hob from being operated unintentionally or intentionally.
Switching on (left cooking zone)
1. Press the Plus key
zone simultaneously until the
cookingzones are locked. As soon as a key is pressed the
will re-appear to remind you of the lock function.
Switching off
2. Press the Plus key
zone simultaneously until the
cooking zones will have been released again.
Note!
• It is possible to switch the cooking zone off if the lock has been activated by
means of pressing the ON/OFF key
• Use the same procedure for locking the right-hand cooking zone.

Safety switch-off

The appliance has an automatic time limit function. It prevents the appliance
from being in operation for a longer period of time.
The timer of the time limit function depends on the setting of the cooking
level: The higher the setting of the cooking level the faster it switches off. The
time limit function operates for each cooking zone seperately.
Important! After switching off the cooking zone, a
display. The letter will remain. In order to acknowledge, press any key of the
respective cooking zone. This will be confirmed when a double signal sounds.

Other functions

If two or more sensors are pressed at the same time – e.g. when a pan is
mistakenly put onto a sensor key – no function is activated. After 10 seconds
the entire electronic system will switch off and dashes
Exception: lock/child safety device.
If you continue to press a sensor key after having set the highest cooking
setting, the electronics switch off automatically after 10 seconds.
The appliance does not automatically switch on again after a power failure.
The hob is switched off if the electronics become overheated. A row of
dashes or "F7" will appear.

Protection against overheating

If the hob is used at full power for a lengthy period, the power electronics may
no longer be cooled to the necessary extent at room temperature.
To ensure that no excessive temperatures occur in the electronics, the power
of the cooking zones may be reduced automatically.
If, during normal use of the hob and at normal room temperature, a row of
dashes or "F7" appears frequently in the cooking setting display, the cooling
is probably not sufficient. The cause may be that the kitchen units do not
have any openings for cooling purposes or that they do not have any
screening. If necessary installation must be checked.
and the Minus key of the front left cooking
symbol is shown. Both of the left-hand
and the Minus key of the front left cooking
symbol goes off. Both of the left-hand
. The lock will remain activated.
GB
symbol
will appear in the
will appear.