Dell Alienware Aurora R8 Service Manual page 105

Table 4. System setup options—Advanced menu
Advanced
Advanced BIOS Features
Intel SpeedStep
Virtualization
VT for Direct I/O
SATA Operation
Intel Ready Mode Technology
Intel Software Guard Extensions
BIOS Recovery from Hard Drive
USB Configuration
Front USB Ports
Rear USB Ports
Power Options
Numlock Key
Wake Up by Integrated LAN
AC Recovery
Deep Sleep Control
USB Wake Support (S3)
USB PowerShare (S4/S5)
USB PowerShare Wake Support (S4/S5)
Auto Power On
Auto Power On Mode
Auto Power On Date
Auto Power On Time
Allows you to enable or disable Intel Speedstep Technology.
Default: Enabled.
NOTE: If enabled, the processor clock speed and core
voltage are adjusted dynamically based on the
processor load.
Allows you to enable or disable Intel Virtualization Technology
feature for the processor.
Allows you to enable or disable Intel Virtualization Technology
feature for the Direct I/O.
Allows you to configure the operating mode of the integrated
SATA hard drive controller.
Allows you to enable or disable the Intel Ready Mode
Technology.
Allows you to enable or disable Intel Software Guard
Extensions.
Allows you to enable or disable BIOS Recovery from hard
drive.
Allows you to enable or disable the front USB ports.
Allows you to enable or disable the rear USB ports.
Allows you to set the status of the Num Lock key during boot
to On or Off.
Allow the computer to be powered on by special LAN signals.
Sets what action the computer takes when power is restored.
Allows you to define the controls when Deep Sleep is
enabled.
Allows you to enable the USB devices to wake the system from
Standby.
Allows you to charge external devices.
Allows you to enable front the USB devices to wake the
system from S4/S5.
Allows you to set the computer to turn on automatically every
day or on a preselected date. This option can be configured
only if the Auto Power On mode is set to Enabled Everyday or
Selected Day.
Allows you to set the date on which the computer must turn on
automatically. This option can be configured only if the Auto
Power On mode is set to Enabled 1 to 31.
Allows you to set the time at which the computer must turn on
automatically. This option can be configured only if the Auto
Power On mode is set to Enabled hh:mm:ss.
105