Spanning-Tree Mst Cost - SMC Networks TigerAccess SMC7816M Management Manual

S T
PANNING REE

spanning-tree mst cost

This command configures the path cost on a spanning instance in the
Multiple Spanning Tree. Use the no form to restore the default
auto-configuration mode.
Syntax
spanning-tree mst instance_id cost cost
no spanning-tree mst instance_id cost
• instance_id - Instance identifier of the spanning tree.
(Range: 0-4094, no leading zeroes)
• cost - Path cost for an interface.
(Range: 0 for auto-configuration, 1-65535 for short path cost
method
The recommended path cost range is listed in Table 31-2
on page 31-16. The recommended path cost is listed in
Table 31-3 on page 31-16.
Default Setting
By default, the system automatically detects the speed and duplex mode
used on each port, and configures the path cost according to the values
shown below. Path cost "0" is used to indicate auto-configuration
mode. When the short path cost method is selected and the default
path cost recommended by the IEEE 8021w standard exceeds 65,535,
the default is set to 65,535. The default path costs are listed in
Table 31-4 on page 31-17.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Each spanning-tree instance is associated with a unique set of VLAN
IDs.
• This command is used by the multiple spanning-tree algorithm to
determine the best path between devices. Therefore, lower values
35. Use the spanning-tree pathcost method command on page 31-9 to set the path cost method.
31-22
C
OMMANDS
35
, 1-200,000,000 for long path cost method)