Configuring Client Pcs; Tcp/Ip Configuration - SMC Networks SMC Barricade SMC7004VWBR User Manual

C
ONFIGURING

TCP/IP Configuration

To access the Internet through the Wireless Barricade, you must configure
the network settings of the computers on your LAN to use the same IP
subnet as the Wireless Barricade. The default network settings for the
Wireless Barricade are:
IP Address: 192.168.2.1
Subnet Mask: 255.255.255.0
Note: These settings may be changed to suit your network requirements,
but you must first configure at least one computer as described in
Chapter 5 to access the Wireless Barricade's web configuration
interface. (See Chapter 4 for information on configuring the
Wireless Barricade.)
If you have not previously configured TCP/IP for your computer, refer to
"Configuring Client TCP/IP" on page 5-1.
All PCs connected to the Wireless Barricade must be in the same IP subnet
as the Wireless Barricade. The default IP address of the Wireless Barricade
is 192.168.2.1 (where x means 2–254) and the subnet mask is
255.255.255.0. You can set the IP address for client PCs either by
automatically obtaining an IP address from the Wireless Barricade's DHCP
service or by manual configuration. See "Setting Up TCP/IP to Work with
the Wireless Barricade" on page 5-5.
C
HAPTER
C
LIENT
3
PC
S
3-1