Configuring Client Pcs; Tcp/Ip Configuration - SMC Networks Barricade SMC7004AWBR User Manual

C
ONFIGURING

TCP/IP Configuration

To access the Internet through the Barricade
Router, you must configure the network settings of the computers
on your LAN to use the same IP subnet as the Wireless Barricade.
The default network settings for the Wireless Barricade are:
IP Address: 192.168.2.1
Subnet Mask: 255.255.255.0
Note: These settings can be changed to fit your network
requirements, but you must first configure at least one
computer as described in Chapter 5 to access the Wireless
Barricade's Web configuration interface. (See Chapter 4 for
information on configuring the Wireless Barricade.)
If you have not previously configured TCP/IP for your computer,
refer to "Installing TCP/IP Protocol in Your PC" on page 5-1.
All PCs connected to the Wireless Barricade must be set to the
same IP subnet as the Wireless Barricade. The default IP address
pool of the Wireless Barricade is 192.168.2.X (where X means
2–254) and the subnet mask is 255.255.255.0. You can set the IP
address for client PCs either by automatically obtaining an IP
address from the Wireless Barricade's DHCP service or by manual
configuration. See "Setting TCP/IP to Work with the Barricade" on
page 5-3.
C
HAPTER
C
LIENT
Wireless Broadband
™
3
PC
S
3-1