Snmpv3 Configuration Example - Avaya ERS 2500 Technical Configuration Manual

10.9.3 SNMPv3 Configuration Example

Assuming we wish to add the following users:

SNMPv3 authPriv user using a user name of userro with authentication based on MD5
with an authentication password of readonly, privacy protocol of 3DES using a password
of despasswdro.

SNMPv3 authPriv user using a user name of userrw with authentication based on MD5
with an authentication password of readwrite, privacy protocol of 3DES using a password
of despasswd.
ERS- STACKABLE: Step 1 – Enable SNMP
ERS-Stackable(config)# snmp-server enable
ERS-STACKABLE: Step 1 – Add SNMPv3 authPriv read-only user
ERS-Stackable(config)# snmp-server user userr0 md5 readonly 3des despasswdro
read-view snmpv1Objs
If using password security is enabled:
ERS-Stackable(config)# snmp-server user userro md5 read-view snmpv1Objs 3des
read-view snmpv1Objs
Enter MD5 pass-phrase: ******** (readonly)
Confirm MD5 pass-phrase: ******** (readonly)
Enter 3Des pass-phrase: *********** (despasswdro)
Confirm 3Des pass-phrase: *********** (despasswdro)
ERS-STACKABLE: Step 2 – Add SNMPv3 authPriv read-write user
ERS-Stackable(config)# snmp-server user userrw md5 readwrite 3des despasswdrw
write-view snmpv1Objs read-view snmpv1Objs
If using password security is enabled:
ERS-Stackable(config)# snmp-server user userrw md5 3des read-view snmpv1Objs
write-view snmpv1Objs
Enter MD5 pass-phrase: ********* (readwrite)
Confirm MD5 pass-phrase: ********* (readwrite)
Enter 3Des pass-phrase: *********** (despasswdrw)
Confirm 3Des pass-phrase: *********** (despasswdrw)
 The SNMP view name used in this example is one of the default MIB view on the
Ethernet Routing Switch which can be viewed by entering the CLI command show
snmp-server view.
Avaya Inc. – External Distribution
avaya.com
56