Transport With A Fork-Lift Truck; Transport With A Crane - Siemens SINAMICS SM120 Operating Instructions Manual

4.3.4

Transport with a fork-lift truck

Use of non-approved fork-lift trucks
If the forks are too short, this can cause the transport unit/cabinet to tip over resulting in death,
serious injury, or damage to the cabinet.
The forks of the truck must protrude at the rear of the transport pallet. The floor panels of the
transport units will not support a load.
Only use fork-lift trucks approved for this purpose to transport the units.
When the transport units are transported or moved with a fork-lift truck, the force is absorbed
through the transport pallet.
Observe the following points for safe transport:
● Transport the transport unit/cabinet with the greatest care.
● Choose the lowest transport height possible. The pallet may not touch the ground. Always
● Avoid driving over bumps.
4.3.5

Transport with a crane

Improper transport
If the transport unit is not properly transported with a crane, the transport unit/cabinet could
fall or tip over This can result in death, serious injury or material damage.
Make sure that you read the safety information about transportation and the information
provided on the transport unit (e.g. center of gravity specifications).
Use of inappropriate cross-arms
If inappropriate cross-arms are used, the transport unit or cabinet can tip over. This can result
in death, serious injury or material damage.
Observe the specifications provided in DIN EN 13155 on crossbars.
SINAMICS SM120 6SL38715
Operating Instructions 07/2015
WARNING
transport the cabinet in an upright position.
WARNING
WARNING
Preparations for use
4.3 Transport
55