Activating Live Mode; Ie Night Exposures - Kompernass WK 5 A1 Operating Instructions Manual

Activating live mode

GB
Live mode is the standard operating mode of the camera. In this
IE
mode, recordings are triggered via the motion sensors
live mode, slide the operating mode selector switch
position. After fifteen seconds the red LED of the standby indicator
will go off. Then the camera will start to operate independently and
will go into standby mode. As soon as any wild or other animals or
people enter the detection range of the central sensor zone, the
camera will start capturing photos and/or videos (depending on
the configuration).
If wild animals enter the detection range of the side motion sensors
, these will detect the motion and activate the camera. If the wild
7
animals continue to move in front of the front motion sensor
camera will continue taking photos/videos. When the wild animals
leave the detection range of the side motion sensors
switches off and goes back into standby mode.
Night exposures
During night exposures the infrared LEDs
provide the required light for making recordings possible. The LEDs
emit light over a wide angle. This makes it possible to make night
recordings at a distance of about 3 m to 20 m without overexpos-
ing the subject. However, reflective objects such as traffic signs can
cause overexposure if they are located within the recording range.
Please note that night exposures are made in black and white.
30
6
to the "ON"
18
, the camera
7
on the front of the camera
1
, . To set
7
2
, the
6
WK 5 A1