Kompernass WK 5 A1 Operating Instructions Manual page 29

♦ Insert the memory card into the device while the mode selector
switch is set to the OFF position.
18
♦ Keep the
switch to the TEST position. Keep the
until the display
Keep table".
♦ After around 25 seconds the camera switches off.
♦ Switch the camera back on by moving the mode selector switch
to the OFF position and then to the TEST position. The camera
can now be used without entering a password.
NOTICE
► This procedure will permanently delete any previously made
settings and return the device to the factory settings.
Beep sound
The device allows you to select whether or not you wish to hear an
audible signal (default setting) when you press a button.
Format memory card
Formatting the microSDHC memory card
all data on it. Before you use a new memory card in the camera or
a card that has previously been used in another device, you should
first format the memory card.
♦ In this case, select the setting "YES" with the
formatting process starts. While the card is being formatted,
the message "Please wait" appears.
WK 5 A1
button pressed while moving the mode selector
shows the notification "Firmware upgrading...
10
button pressed down
will permanently delete
34
button. The
GB
IE
25