Olympus FL-700WR Instructions Manual page 56

Setting the communication group/channel in the X-RCV mode
• Select the same group and the same channel that
you set on the wireless commander/commander
fl ash.
Press the MODE button. Then, press HI on the
arrow pad to highlight G/CH (communication
group/communication channel). Turn the dial to
adjust the setting.
• You can select from A1 to A15, B1 to B15, and C1
to C15.
Press the OK button.
Setting the fi ring frequency (Hz) and number of fi rings (TIME)
• This procedure is necessary only when you select the MULTI mode in Step
2. Refer to "Firing the Flash Repeatedly at a Regular Interval (MULTI Mode)"
(P. 45) for details.
Optical Wireless Functions
Wireless RC fl ash shooting allows you to use the camera settings to control
multiple fl ashes through optical communications. This function only works with
Olympus digital cameras that support the wireless RC mode.
Optical slave shooting allows you to control the fl ash through optical
communications. This function works even with products that do not support the
RC mode.
The fl ash may not fi re properly in the following situations.
• Something is blocking the light from the commander fl ash.
• The receiver is outside the range of the commander fl ash.
• The commander fl ash and the receiver are too far apart.
• The sensor window of the receiver is not correctly facing the commander fl ash.
• The receiver is in a bright environment, such as outside on a sunny day.
Refer to the camera manual as well.
56
EN
MODE ZOOM G/CH
A
M 75
A11
mm
RATIO
1/128