Table of Contents
Advertisement
13. Remote Operation with External Controller
Repeater operation may be controlled remotely by connecting an external controller through the [ CONTROL
I/O ] connector at the back of the repeater.
The following features are available while in remote operation:
•
Change the communication mode of repeater transmit and receive
•
Turn the RX and TX tone signal "ON" or "OFF"
•
Monitor the discriminator analog or demodulated digital audio during up-link reception
To use the repeater under remote control, set up the repeater as explained below, after it is connected to the
external controller.
Turning remote operation ON/OFF
When the remote operation is "ON", the repeater operates according to the control instructions received from
the external controller (the instructions are received through Pin 11 to Pin 14 of the [ CONTROL I/O ] connector).
When the remote operation is "OFF", the repeater operates according to the settings determined through the
setup mode.
1 Touch [ SETUP ] .
The setup mode screen will appear.
2 Touch [ F ] .
The setup menu will appear.
3 Touch [ MODE/REMOTE ] .
The menu list will appear.
4 Touch [ REMOTE ] .
The set value will change between [ OFF ] and [ ON ] each time
[ REMOTE ] is touched.
z Factory default: OFF
z Remote operation is not available in the "HRI + REPEATER MODE".
5 Touch [ BACK ] 3 times.
The setting is determined and the display will return to the operation mode screen.
Note that [ REMOTE ] at the bottom left of the screen is displayed in red.
You can transmit by the microphone and PTT input of the front panel in all settings except AMS/AMS.
Control from external controller
To control the DR-1X remotely, optional cables can be used to connect
the repeater to an external controller.
Use the "CONTROL I/O" connector at the back of the repeater to con-
nect with the external controller.
To interface the DR-1X with an external controller, additional cables
with a 15-pin mini d-sub connector are needed to connect to the
"CONTROL I/O" connector. Your controller may also require rewiring.
Link operation may require four connections: receiver audio, transmit-
ter audio, receiver COR, and transmitter PTT; however, these are not
available on the "CONTROL I/O" connector.
The pin assignment of the "CONTROL I/O" connector is as follows.
Do not use a VGA cable for PC display to connect the external controller
to the repeater.
S E T U P
V e r . 1 . x x x E X P A 1
U P
L
I
N K
ID MODE
D O W N
L
I
N K
���������
TIMER ID ANNOUNCE
D G - I D
SQL
MODE/REMOTE
ID SET
R - O F F
T - O F F
Tx PW R
V
/
M
S Q L
BACK
BACK
H I
REMOTE / COMMAND / DISP TIMER
REMOTE
DG-ID
COMMAND
DISPLAY TIMER
BACK
V
/
M
BACK
CONTROL I/O connector
5 - 1
10 - 6
15 - 11
(as viewed from real panel)
DEVIATION
WIDE
F
ON
>
>
ON
33
Advertisement
Table of Contents
