Inspection - MULTIQUIP MVH408DZ Operation And Parts Manual

BEFORE STARTING
1. Read all safety instructions at the beginning of manual.
2. Clean the compactor, removing dirt and dust,
particularly the engine cooling air inlet, carburetor and
air cleaner.
3. Check the air filter for dirt and dust. If air filter is dirty,
replace air filter with a new one as required.
4. Check carburetor for external dirt and dust. Clean with
dry compressed air.
5. Check fastening nuts and bolts for tightness.
ENGINE OIL CHECK
1. To check the engine oil level, place the compactor on
secure level ground with the engine stopped. If the oil
level is low, add oil (Grade CC or above).
2. Lubrication is done from the top of the engine (Figure 4).
Oil inlet at the top
Figure 4. Adding Engine Oil
NOTICE
Pour oil slowly from the top. Oil might overflow if large
amount of oil is poured right away.
Table 4. Oil Type
Season Temperature
Summer 25°C or Higher
Spring/Fall 25°C~10°C
Winter 0°C or Lower
MVH408DZ PLATE COMPACTOR • OPERATION AND PARTS MANUAL — REV. #7 (03/07/19)— PAGE 17
FUEL CHECK
1. The fuel tank cap is equipped with a lock lever. Unlock
1. Visually inspect to see if fuel level is low. If fuel is low,
Oil Type
SAE 10W-30
2. When refueling, be sure to use a strainer for filtration.
SAE 10W-30/20
SAE 10W-10
DANGER
EXPLOSIVE FUEL!
Motor fuels are highly flammable and can
be dangerous if mishandled. DO NOT
smoke while refueling. DO NOT attempt
to refuel the compactor if the engine is
hot or running.
the lever before opening cap (Figure 5).
Lock lever
Put your finger at the lock lever
to pull it up towards you.
Put your fingers to the tabs at
the two locations of the tank
cap to pull up towards you.
Figure 5. Unlocking Fuel Cap Lever
replenish with unleaded fuel. Fuel inlet is located under
the rubber cover at the front cover top portion.
DO NOT top-off fuel. Wipe up any spilled fuel
immediately.

INSPECTION

Fuel tank cap
Unlock the lock lever.