Inspection - MULTIQUIP V305EH Operation And Parts Manual

BEFORE STARTING
1. Read safety information at the beginning of manual.
2. Remove dirt and dust, particularly in the engine cooling
air inlet, carburetor and air cleaner.
3. Check the air filter for dirt and dust. If air filter is dirty,
replace air filter with a new one.
4. Check carburetor for external dirt and dust. Clean with
dry compressed air.
5. Check fastening nuts and bolts for tightness.
6. Understand the geographical features and regulations
of the job site.
ENGINE OIL CHECK
1. To check the engine oil level, place the machine on
secure level ground with the engine stopped.
2. Remove the filler dipstick from the engine oil filler hole
(Figure 9) and wipe clean.
Figure 9. Engine Oil Dipstick
3. Insert and remove the dipstick without screwing it into
the filler neck. Check the oil level shown on the dipstick
(Figure 10).
4. If the oil level is low, fill to the edge of the oil filler hole
with the recommended oil type (Table 4). Maximum oil
capacity is 1.16 quarts (1.1 liters).
Table 4. Oil Type
Season Temperature
Summer 25°C or Higher
Spring/Fall 25°C~10°C
Winter 0°C or Lower
PAGE 20 — V305EH VIBRATORY ROLLER • OPERATION AND PARTS MANUAL — REV. #1 (06/21/16)
FUEL CHECK
1. Remove the fuel cap of the filler port located on top of
Oil Type
SAE 10W-30
SAE 10W-30/20
2. Visually inspect to see if the fuel level is low. If fuel is
SAE 10W-10
LOWER LIMIT
Figure 10. Engine Oil Level
NOTICE
The V305EH roller has an Oil Alert System. This
system will automatically stop the in the event of low
oil level. ALWAYS be sure to check the engine oil level
prior to starting the engine.
DANGER
Motor fuel is highly flammable and can be
dangerous if mishandled. DO NOT smoke
while refueling. DO NOT attempt to refuel
the pump if the engine is hot or running.
the engine fuel tank (Figure 11).
Figure 11. Fuel Tank Filler Port
low, replenish with unleaded gasoline using a strainer

INSPECTION

UPPER LIMIT
FUEL TANK
FILLER PORT