Bowflex BXT6 Service Manual page 50

13. Disconnect the old Middle I/O Cable from the Upper I/O Cable at the
top of the Right Upright.
Note: Be sure not to allow the old Middle I/O Cable to fall down into the
Right Upright.
14. Gently pull the old Middle I/O Cable from the Right Upright, routing
the new I/O Cable through the Right Upright.
Note: Be sure the cable does not crimp when being routed.
15. Disconnect the old Middle I/O Cable, and dispose of it appropriately.
16. Connect the new Middle I/O Cable to the Upper I/O Cable.
17. Re-install all remaining parts that were removed in reverse order. Be
sure the Cables are safely tucked into the Right Upright.
18. Safely tilt the right side of the machine up, remove the incompress-
ible block or book from under the Base Assembly, and safely lower the
machine.
19. Make sure there is sufficient space to lower the walking deck.
Keep a minimum clearance behind the machine of 79" (2 m)
and 24" (0.6 m) on each side. This is the recommended safe
distance for access, movement and emergency dismounts
from the machine.
20. Make sure there is no object on or around the treadmill to spill or
cause blockage from the fully unfolded position.
21. Slightly push the walking deck forward toward the console. With
your foot lightly push the top part of the hydraulic lift forward until the
locking tube releases and you can pull the walking deck away from the
console. Hold up the rear of the walking deck, and move to the side of the
machine.
Keep clear of the movement path of the walking deck.
22. The hydraulic lift is set up to drop gradually. Hold onto the walking
deck until approximately 2/3 of the movement down. Make sure that
you use proper lifting technique; bend your knees and keep your back
straight. Be aware that the walking deck can possibly drop quickly in the
last part of the movement.
50