Bowflex BXT6 Service Manual page 28

Walking Belt stops while in use, moves briefly, or does not move at all (Console lights up)
If the Console powers up and the Start
BEGIN HERE:
button beeps or causes the Display to
change, then the Console is NOT defective.
Turn machine power off
for at least 5 seconds
before turning back on.
Begin a quickstart/manual
workout.
Replace Speed Sensor
NO
Does the Belt move
at all?
YES
Shut off machine and wait
5 minutes. Remove Motor
and MCB Cover. Verify
Speed Sensor is properly
aligned and check Sensor
and wire for damage.
YES
Does sensor/wire
need replacement?
NO
YES
Is the issue still
present?
NO
Issue resolved
Perform Service Mode
Procedure 2 to test
Console communications
YES
Did the
belt move for a few
seconds and then
stop?
NO
Perform Service Mode
Procedure 2 to test
Console communications
28
Replace I/O Cables
NO
Did communication
test pass?
YES
Disconnect machine
power for 1 minute. Follow
Service Mode Procedure
3 to reset Console, then
Service Mode Procedure
4 to calibrate the MCB.
Is the issue still
YES
present?
NO
Issue resolved
Contact Customer Care
(if inside US/Canada)
or your local distributor
(if outside US/Canada).