Igniter Replacement; Glass Replacement - Quadra-Fire SANTAFEI-MBK Owner's Manual

Santa Fe Pellet Insert
D. Igniter Replacement
a. Shut down the appliance by turning down the
thermostat and let the appliance completely cool down.
After the appliance has cooled down, unplug it and
remove the ash drawer.
b. The wire leads to the igniter are connected to the
wire harness with 1/4 inch (6mm) male / female
spade connectors. These wires will pull forward
approximately 4 to 5 inches (102mm to 127mm)
through the grommet at the back of the ash drawer
chamber. Disconnect the spade connections and
remove the igniter from the chamber. Loose the thumb
screw and slide igniter out.
c. Install new igniter into the chamber and tighten the
thumb screw. Re-connect the wires to the 2 leads with
the spade connectors.
d. Push excess wire leads back through the grommet, one
wire at a time, to take-up the 4 to 5 inches (102mm to
107mm) previously pulled out. This will keep the wires
out of the way of the ash drawer. Double check that
the igniter wires are clear of any movement, i.e. ash
drawer, fire pot cleaning rod, cleaning slide plates, etc.
e. Re-install the ash drawer and then re-install the side
panel and re-connect the power.
Igniter Bracket
Thumb Screw
Figure 28.1
28
E. Glass Replacement
a. The door handle and face must be removed
b. Remove door from the insert and lay on a flat surface
c. Using a screwdriver, tap the bottom of the rope retainer
d. Remove old glass and replace with new glass.
e. Slide the retainer rod into the top hole first, and then
Igniter
7019-229G
first. Follow instructions found on page 18 of the
installation manual.
face down.
rod to push it up out of the hole. The top end of the rod
will slide up. Swing the rod toward you from the bottom
and remove the rod. Repeat for other side.
line up the bottom crimped end with the hole in the
door. The crimped end must be parallel with the glass
in order to insert it into place (Figure 28.2).
Glass
Figure 28.2
WARNING
• Glass is 5mm thick high temperature heat-
resistant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause
injury.
Rope Retainer
Rods
Slide this
end in first
Crimped end
at the bottom
Crimped end must be
parallel with the glass
August 3, 2018