Lan Setup - NETGEAR MBR1515 User Manual

¾
To assign a computer or server to be a default DMZ server:
1. Go to the WAN Setup screen as described in the previous section.
2. Select the Default DMZ Server check box.
3. Type the IP address for that server.
4. Click Apply to save your changes.

LAN Setup

The LAN Setup screen allows configuration of LAN IP services such as DHCP and RIP.
These features can be found under Advanced in the router main menu.
The router is shipped preconfigured to use private IP addresses on the LAN side, and to act
as a DHCP server. The router default LAN IP configuration is:
• LAN IP address. 192.168.0.1
• Subnet mask. 255.255.255.0
These addresses are part of the Internet Engineering Task Force (IETF)–designated private
address range for use in private networks, and should be suitable in most applications. If your
network has a requirement to use a different IP addressing scheme, you can make those
changes in this screen.
Tip: If you change the LAN IP address of the router while connected through
the browser, you will be disconnected, and so will others connected to
the router. To connect to the router, you must open a new connection to
the new IP address and log in again. Others using the router must restart
their computers to connect to the router again.
¾
To view or change the LAN setup:
1. Select LAN IP to display the LAN Setup screen.
2. Change the settings. For more information, see
Addresses on page 69.
LTE Broadband 11n Wireless Router MBR1515
Advanced
67
DHCP Settings on page 68, or Reserved IP