Belkin Vision Wireless Router N1 User Manual page 57

Using the Web-Based Advanced User Interface
Using Wi-Fi Protected Setup
WPS uses WPA2 (described below) for encryption. It does not
provide additional security, but rather, standardizes the method for
securing your wireless network. You may use either the Push Button
Configuration (PBC) method or PIN method to allow a device access to
your wireless network. Conceptually, the two methods work as follows:
PBC: Push and hold the WPS button located on the back of your N1
Vision for three seconds. Then, initiate the WPS procedure on the client
device within two minutes. Refer to your client's documentation on this
procedure. Pushing the PBC button will automatically enable WPS. The
client has now been securely added to your wireless network.
PIN: The client device has a PIN number (either four or eight
digits) that is associated with WPS. Enable WPS through the
screen illustrated below. Enter the client's PIN into the N1 Vision's
internal registrar (accessed through this screen). The client will be
automatically enrolled into your wireless network within two minutes.
53 53
(1)
(2)
(3)
(4)
(5)
1
2
3
4
5
6
7
8
9
10