Yamaha MODX7 Reference Manual page 194

Reference
Performance
MIDI I/O Mode
Determines which MIDI I/O mode is used for data communication between this instrument and an external
device.
Settings: Multi, Single
Multi: Transmits MIDI data such as Note On/Off messages for each Part.
Single:
Transmits MIDI data using only the channel specified in "MIDI I/O Ch."
MIDI I/O Ch. (MIDI I/O channel)
Determines the MIDI channel to be used for data communication when "MIDI I/O Mode" is set to "Single."
Settings: Ch1–16
When this parameter is set to "Single," Arpeggio data is not transmitted to the external device. When the Zone
function is active, the Zone setting for the Performance is given priority over the "MIDI I/O Mode" setting. You can see
which setting is active from the MIDI Signal Flow in the MIDI I/O display.
Device Number
Determines the MIDI Device Number. This number must match the Device Number of the external MIDI
device when transmitting/receiving bulk data, parameter changes or other System Exclusive messages.
Settings: 1–16, All, Off
Bank Select
This switch enables or disables Bank Select messages, both in transmission and reception. When this is
set to "on," this synthesizer responds to incoming Bank Select messages.
Settings:
Off, On
Pgm Change (Program Change)
This switch enables or disables Program Change messages, both in transmission and reception. When
this is set to "on," this synthesizer responds to incoming Program Change messages.
Settings:
Off, On
Receive Bulk
Determines whether or not Bulk Dump data can be received.
Settings: Protect (not received), On (received)
Bulk Interval
Determines the interval time of the Bulk Dump transmission when a Bulk Dump Request is received.
Settings: 0ms–900ms
Event Chase (Song Event Chase)
Event Chase allows you to specify which non-note data types are properly recognized during fast-forward
and rewind operations. Setting this to a specific event ensures the playback integrity of the event, even
when fast forwarding or rewinding.
Settings:
Off, PC (Program Change), PC+PB+Ctrl (Program Change+Pitch Bend+Control Change)
Init On Boot (Initialize User Data on Boot-up)
Determines whether the User Data is initialized (On) or not (Off) when the power of the instrument is turned
on.
Settings: Off, On
Initialize Advanced Settings
Initializes the system settings edited in the Advanced display.
When the Initialize operation is executed, the target data and system settings you edited will be erased. Make
sure you are not overwriting any important data. Be sure to save all important data to your USB flash drive before
executing this procedure.
MODX Reference Manual
Edit Search Utility Live Set
Uitlity
Settings
Sound
Quick Setup
Audio I/O
MIDI I/O
Advanced
System
Contents
Load
Store / Save
Data Utility
Library Import
Tempo Settings
Effect Switch
Other Info
Shift Function
Legal Notices
194