Ink Refill Assy - Brother MFC Series Service Manual

9.15 Ink refill ASSY

Tip When the Head/carriage unit has not been removed, refer to
CR Timing Belt / Head/Carriage Unit"
the Head/carriage unit.
(1) <For Ink tank models only>
If the Ink refill ASSY contains ink, use a Ink extraction syringe to extract the ink.
(2) Remove the Ink supply tubes (4 tubes) from the tube guide on top of the Tube support
plate, take out the sponge, and remove it from the Tube support wire.
(3) Take out the Ink absorber box from the Lower cover.
Tip When the Main PCB ASSY has not been removed, disconnect the Ink sensor flat
cable from the Main PCB ASSY.
(4) Remove the Ink sensor flat cable from the Lower cover.
(5) <For Ink tank models only>
Slightly slide the Ink refill ASSY to the rear with the Ink refill cap opened, and remove
the four Ink refill caps from the Ink refill ASSY.
in this chapter to remove the Ink supply tubes from
Ink extraction syringe
Ink refill ASSY
Lower cover
Ink refill caps
3-73
"9.3 Head Joint Rubber /
Ink refill ASSY
Lower cover
(3_131L)
(3_132L)
Confidential