Use In Hazardous Areas - Siemens SIWAREX JB Operating Instructions Manual

2.3

Use in hazardous areas

Qualified personnel for hazardous area applications
Persons who install, connect, commission, operate, and service the device in a hazardous
area must have the following specific qualifications:
● They are authorized, trained or instructed in operating and maintaining devices and
systems according to the safety regulations for electrical circuits, high pressures,
aggressive, and hazardous media.
● They are authorized, trained, or instructed in carrying out work on electrical circuits for
hazardous systems.
● They are trained or instructed in maintenance and use of appropriate safety equipment
according to the pertinent safety regulations.
Use in hazardous areas
Risk of explosion.
• Only use equipment that is approved for use in the intended hazardous area and
Loss of safety of device with type of protection "Intrinsic safety Ex i"
If the device has already been operated in non-intrinsically safe circuits or the electrical
specifications have not been observed, the safety of the device is no longer ensured for use
in hazardous areas. There is a risk of explosion.
• Connect the device with type of protection "Intrinsic safety" solely to an intrinsically safe
• Observe the specifications for the electrical data on the certificate and/or in Technical
SIWAREX JB
Operating Instructions, 12/2017, A5E43011851-AA
WARNING
labelled accordingly.
WARNING
circuit.
data (Page 33).
Safety information
2.3 Use in hazardous areas
11