Requirements For Special Applications; Use In Hazardous Areas; Qualified Personnel For Hazardous Area Applications - Siemens SITRANS TS100 Compact Operating Instructions

2.3

Requirements for special applications

Due to the large number of possible applications, each detail of the described device
versions for each possible scenario during commissioning, operation, maintenance or
operation in systems cannot be considered in the instructions. If you need additional
information not covered by these instructions, contact your local Siemens office or company
representative.
Note
Operation under special ambient conditions
We highly recommend that you contact your Siemens representative or our application
department before you operate the device under special ambient conditions as can be
encountered in nuclear power plants or when the device is used for research and
development purposes.
2.4

Use in hazardous areas

2.4.1

Qualified personnel for hazardous area applications

Qualified personnel for hazardous area applications
Persons who install, connect, commission, operate, and service the device in a hazardous
area must have the following specific qualifications:
● They are authorized, trained or instructed in operating and maintaining devices and
systems according to the safety regulations for electrical circuits, high pressures,
aggressive, and hazardous media.
● They are authorized, trained, or instructed in carrying out work on electrical circuits for
hazardous systems.
● They are trained or instructed in maintenance and use of appropriate safety equipment
according to the pertinent safety regulations.
Use in hazardous area
Risk of explosion.
• Only use equipment that is approved for use in the intended hazardous area and
• Don't use devices that have been operated outside the conditions secified for hazardous
TS100/TS200/TS300/TS500/TSinsert/TSthermowell
Compact Operating Instructions, 01/2018, A5E03920348-AE
WARNING
labelled accordingly.
areas. If you have used the device outside the conditions for hazardous areas
permanently make all Ex markings unrecognizable on the nameplate.
2.3 Requirements for special applications
Safety notes
13