Specifications; Interior Compartment/Sidewall Opening Requirements - Dometic 441003.701 Installation Instructions Manual

SPECIFICATIONS

A. Table - Unit Data
Model No. Nominal Electrical
Capacity Rating*
(BTU HR)
Cooling
441003.701 10,150 120 Vac
60 Hz 1 ph
441003A701 10,150
* Maximum unit performance achieved at full rated voltage.
** For wire length over 24 ft., consult the National Electrical Code for proper sizing.
*** Dometic Corporation gives GENERAL guidelines for generator requirements. These guidelines come from experiences
people have had in actual applications. When sizing the generator, the total power usage of your RV must be considered.
Keep in mind generators lose power at high altitudes and from lack of maintenance.
**** CIRCUIT PROTECTION: Time Delay Fuse or Circuit Breaker Required.
B.

Interior Compartment/Sidewall Opening Requirements

1. A dedicated interior compartment MUST BE provided for the unit installation. This compartment MUST BE OPEN
TO THE OUTSIDE AND AIR SEALED TO THE INSIDE. Interior compartment must be at least 20" deep with an
inside cabinet front cutout of 20" x 14". The opening must be 1" above the mounting surface for the unit.
2. A 22-3/4" wide x 15" high opening through the sidewall or outside panel is required.
Compressor Compressor Fan Motor
Rated Load Locked Rated Load
Amps Rotor Amps
Amps
8.9 50.0 2.2
8.9 50.0 2.2
Fan Motor Refrigerant Minimum
Locked R-410A Wire Size**
Rotor (oz)
Amps
6.6 28.0 12 AWG
Copper
6.6 28.0
Up to 24'
5
AC Circuit Minimum Unit
Protection Generator Width
****Installer Size***
Supplied 1 Unit / 2 Units
20 Amp 2.8 kW / 40 kW 22"
20 Amp 2.8 kW / 4.0 kW 22"
Unit Unit Installed
Height Depth Weight
(Pounds)
14.5" 20.5" 70
14.5" 20.5" 70