Error Messages - KDF Zircom Instruction Manual

The unit shows a warning display as shown below. When there is an error sign, please follow
the instruction carefully. When contacting our technical support team, please provide the error number.
In the case when the unit is showing a warning sign due to abnormal or excessively loud noise,
please turn off the unit and turn it back on.
Caution) In the case of rebooting the unit, the contents of the initial value and the program may be deleted.
The followings are examples of abnormal or excessively
loud noise
・Lightning strike nearby, lightning
・Equipment high frequency casting equipment, such
as arc casting apparatus
・Wireless device
・Motorized equipment
WARNING
No.2 Controller abnormal
Error 2 is displayed when the controller is operating abnormally due to abnormal or excessively loud noise.
No.4 Lifting Table abnormal
Error 4 is displayed when error occurs during lifting the firing furnace.
No.5 Heater disconnection abnormality
Error5 is displayed when heater is broken. Please replace it with a new muffle.
No.6 Thermocouple Error
Error 6 is displayed when the thermocouple is short-circuited or disconnected.
No.8 Memory Error
Error 8 is displayed if the memory content is corrupted or lost by abnormal or excessively loud noise.
The unit also shows Error 8 when it is unable to read the memory. Turn off the unit and turn it back on to reset.
When you reset, program content may be deleted.
No.9 Excessive rise in temperature anomaly
Error 9 is displayed when the muffle temperature rises excessively.
No.11 Top cooling fan error
Error 11 is displayed when an error occurs in the top cooling fan.
No.12 Under cooling fan error
Error 12 is displayed when an error occurs in the under cooling fan.
No.13 Temperature Control Board error
Error 13 is displayed when an error occurs in the temperature control board inside.
No.14 Current control Board error
Error 14 is displayed when an error occurs in the current control board.

Error Messages

-17-