Service Troubleshooting - Simplicity 1693161 555M Operator's Manual

Service
TROUBLESHOOTING
This section provides troubleshooting and service
instructions. Locate the problem and check the possible
cause/remedy in the order listed.
Also, refer to the engine manufacturer's Owner's Manual
for additional information.
For problems not covered here, contact your local deal-
er.
PROBLEM
Engine fails to start.
Engine starts hard or runs poorly.
Auger does not rotate.
Before performing any adjustment or service to
snowthrower, stop the engine and wait for moving
parts to stop. Remove the key. To prevent accidental
starting, disconnect the spark plug wire and fasten
away from the plug.
POSSIBLE CAUSE
1. Key is OFF.
2. Failure to Prime cold Engine
3. Fuel valve is in CLOSED position.
4. Out of fuel.
5. Choke OFF - cold engine.
6. Engine flooded.
7. Spark plug not sparking.
8. Water in fuel, or old fuel.
1. Fuel mixture too rich.
2. Carburetor adjusted incorrectly.
3. Spark plug faulty, fouled, or gapped
improperly.
1. Auger Control not engaged.
2. Foreign matter blocking auger.
3. Auger drive clutch rod slack.
4. Auger drive belt slipping.
5. Broken belt.
6. Shear pin broken.
14
WARNING
REMEDY
1. Push key in to the ON position.
2. Press Primer Button twice and restart.
3. Turn valve to OPEN position.
4. Fill fuel tank.
5. Turn choke to ON, set throttle to
FAST.
6. Turn choke to OFF; try starting.
7. Check gap. Gap plug, clean elec-
trode, or replace plug as necessary.
8. Drain tank (Dispose of fuel at an
authorized hazardous waste facility).
Fill with fresh fuel.
1. Move choke to OFF position.
2. See your dealer for adjustments.
3. Clean and gap, or replace.
1. Engage Auger Control.
2. STOP engine and REMOVE the key.
DISCONNECT the spark plug wire.
Clear auger using a narrow board.
See warning in SAFETY RULES.
3. Tighten to remove slack. See auger
clutch rod adjustment.
4. Check auger drive belt adjustment.
5. Replace belt.
6. Replace shear pin.