Wiring Provisions For Vehicle Grille Lamps, Flasher And Speaker/Siren - Seo 6J3 - Chevrolet Tahoe 2008 Owner's Manual

Wiring Provisions for Vehicle
Grille Lamps, Flasher and
Speaker/Siren - SEO 6J3
Alternating Signal Flasher
A. Blunt cut ends for the Alternating Signal Flasher,
Customer-Furnished Grille Lamps and
Customer-Furnished Siren/Speaker
B. Control Wires from In-Line Connector in Forward
Lamp Harness for Customer-Furnished Grille Lamps
and Speaker
14-8
This wiring provision option consists of one 16 gauge
2
(1.0 mm ) wire connected to an alternating signal flasher
located underneath the instrument panel on the
passenger side. Five feet (1.5 m) of extra wire from the
flasher is routed from underneath the instrument
panel to an area behind the grille. All four wires have
12 inches (30 cm) of extra wire in a coil behind the grille.
Grille lamps and the speaker are not included.
The flasher is not included when SEO 6J7 is ordered
without SEO 6J3.
The SEO 6J3 wiring provision also includes control
wiring for the SEO 6J7 exterior lamps emergency
flashing system. A dark green/red 18 gauge (0.8 mm
headlamps flasher module control wire activates the
flashing system when 12-volts are applied.
When SEO 6J7 is installed without SEO 6J3, only the
dark green red control wire is provided for connection
to customer-furnished 12-volt switching to turn the
emergency flashing system on or off.
2
)