Shop for Fluke products online at:
Model 113 English Instruction Sheet
CHEK
If a dc or ac voltage greater than about 3 V is present across the inputs
when the meter is set to CHEK, the meter switches automatically to dc
or ac voltage mode and displays the voltage.
When CHEK is activated, the meter has low input impedance (LoZ)
3 k. This load can alter the voltages in electronic control circuits. Do
not use CHEK to measure voltage in circuits that could be damaged by
a 3 k load.
CHEK can be effectively used to eliminate "ghost"
voltages.
AC and DC Voltage
Also refer to Chek.
Volts
Input Impedance 3 k
AC for AC Voltage
DC for DC Voltage
MyFlukeStore
www.
Page 7
Note
6 V
60 V
600 V
RANGE
.com
fda02.eps
1.888.610.7664