Diagnostic And Interrupt; Overview; Process Interrupt - YASKAWA VIPA System MICRO Manual

VIPA System MICRO
xL+
Power supply
1L+
3L+
4L+
xF
Error
4M
5.10

Diagnostic and interrupt

5.10.1

Overview

Hardware interrupt
Diagnostics interrupt
5.10.2

Process interrupt

HB400 | CPU | M13-CCF0000 | en | 18-50
LED
green
LED
green / red
The parametrization allows you to define the following trigger for a hardware interrupt:
n Edge at an digital interrupt input
n Reaching the comparison value
Overflow respectively at overrun upper counter limit
n
n Underflow respectively at underrun lower counter limit
n Opening the HW gate with open SW gate - except for counter 3
n Closing the HW gate with open SW gate - except for counter 3
The VIPA specific parameters allow you to define the following trigger for a diagnostics
Ä Chap. 4.8 'Setting VIPA specific CPU parameters' page 80:
interrupt
n Hardware interrupt lost
n Error: 4L+ DC 24V DO power section supply
n Error: 3L+: DC 24V DI power section supply
n Short circuit overload: DO
An interrupt for the corresponding channel operating mode can only be
triggered if you have additionally parameterized 'Diagnostics+Process' at
'Select interrupt' of the 'Basic parameters' .
Description
DC 24V electronic section supply
DC 24V electronic section supply not available
DC 24V power section supply inputs OK
DC 24V power section supply inputs not available
DC 24V power section supply outputs OK
DC 24V power section supply outputs not available
Description
Error, overload respectively short circuit on the outputs
no error
Deployment I/O periphery
Diagnostic and interrupt > Process interrupt
155