Operation; Activate The Projector; Using The Menus - ViewSonic LS625X User Manual

Operation

Activate the projector

Plug the power cord into the projector and into a wall socket. Turn on the switch on the
wall socket (if available).
Press Power to switch on the projector.
If this is the first time that you've switched on the projector, please refer to on-screen
instructions and select your OSD language.
Switch on all connected equipment.
The projector will then begin a search of the input signals. The lower right corner of the
screen will display the current input signal being scanned. If the projector fails to detect a
valid signal, the screen will display a [NO SIGNAL] message until an input signal is found.
You can press "Source" to select the input signal required. See
details.
If the input signal frequency / resolution is outside the operating range of the projector, the
blank screen will display the [Out of Range] message. Please change to an input signal which is
compatible with the projector's resolution or set the input signal to a lower setting. For more
details, please refer to the [Resolution Table].

Using the menus

This projector has an on-screen display (OSD) menu function that allows you to
change different settings.
The following OSD screenshot is for reference only. Actual OSD design may differ.
The following is an overview of the OSD menu.
Select
Sub-menu
"Switching input signal"
19
for
Main menu
icon
Status
Press "MENU"
to go back to
the previous
window or to
exit.