Advanced Settings - Cisco RV260 series Administration Manual

Wireless
Step 3
Select the network band mode from the Wireless Network Mode drop-down list.
Option
A Only
N/AC-Mixed
A/N/AC-Mixed
Step 4 Click the 20 MHz, 40 MHz, or 80 MHz radio button to select the channel bandwidth.
Note When using 5GHz, however, it is possible to use wider channel bandwidths for increased bandwidth. As such
on the 5GHz channel you can use the 20MHz, 40MHz or even the 80MHz channel bandwidths.
In an environment with less congestion where a higher data throughput is required, using the 40MHz channel
can be a good idea as it still offers 12 non-overlapping channels on 5GHz.
Step 5 Select the primary channel by clicking Lower or Upper.
You can select a primary channel, only if you have selected 40 MHz bandwidth.
Note
Step 6
Select an appropriate wireless channel from the drop-down list. You may select Auto and let the system select the
channel.
Step 7
If you are using battery powered equipment and want to enable the Unscheduled Automatic Power Save Delivery
(U-APSD) mode, check the U-APSD (WMM Power Save).
Step 8 Enter the number of clients in the MAX number of Associated clients to be associated simultaneously.
Step 9
Check Multi-User MIMO to enable. Multi-User Multi-Input and Multi-Output (MU-MIMO) supports environments
where multiple users are trying to access the wireless network at the same time. The MU-MIMO feature enables serving
up to three parallel groups simultaneously on the 5G band.
Step 10 Click Apply.

Advanced Settings

For each radio, you can specify the advanced settings, such as Frame Burst, WMM No Acknowledgment,
Basic Rate, Transmission Rate, DTIM Interval, RTS Threshold, etc.
To configure the advanced settings under Wireless, follow these steps:
Step 1 Click Wireless > Advanced Settings > 2.4G or 5G.
Step 2
Next, configure the following settings:
Frame Burst Check Enable to enable sending multiple frames with minimum inter-frame gap that
enhances network efficiency and reduces overhead.
Description
Select this option if you have only Wireless-A devices in
your network.
Select this option if you have Wireless-N and Wireless-AC
devices in your network.
Select this option if you have Wireless-A, Wireless-N and
Wireless-AC devices in your network.
RV260x Administration Guide
Advanced Settings
67