System; Time - Cisco RV260 series Administration Manual

System Configuration
Step 15
In the Enable Security – Set Router Password section, enter, and confirm the router password. You can check the
Disable Password Strength Enforcement to disable the strength enforcement.
Step 16 Click Next, and in the Network Name field, enter a name for the network.
Step 17
Click Next, and in the Enable Security – Secure your Wireless Network, select the type of network security from the
following options:
• Best Security (WPA2 Personal – AES)
• Recommended for new wireless computers and devices. Older wireless devices may not support this option.
Enter a security key with 8-63 characters or 64 hexadecimal digits, or use the randomly generated security
key, when you choose this option.
• No Security (Not Recommended)
• No additional security settings needed on the device. This mode means that any data transferred to and from
the device is not encrypted.
Step 18
Click Save security settings to save the security settings.
Step 19 Click Print security settings to print a copy of the router's security settings.
Step 20
Click Apply.

System

Assign a host name and a domain name to identify your device to ensure that it is easily identified y other
devices.
Step 1
Click System Configuration > System.
Step 2 In the Host Name field, enter a name to identify the device uniquely on your network. For example, Router001.
Step 3
In the Domain Name field, enter a domain in which your device is located. For example, example.com. If you do not
know the name of your organization's domain, contact your network administrator.
Step 4
Click Apply to apply your changes.

Time

Setting the time is critical for a network device so that every system log and error message is timestamped
for accurate tracking and synchronizing the data transfer with other network devices.
You can configure the time zone, adjust for daylight savings time if necessary, and select the Network Time
Protocol (NTP) server to synchronize the date and time.
To configure the time and NTP server settings, follow these steps:
Step 1 Click System Configuration > Time.
RV260x Administration Guide
System
33