Table of Contents
Advertisement
Ethernet/Cellular Programming Options
E
THERNET
The Programming Sections described in this document can be viewed at the keypad LCD. To start
programming enter: [*][8][installer code] [851][# # # ], Where # # # is the 3 digit section number
referenced in this section. The Programming Worksheets at the end of this document can be used
to record the new values when programming changes have been made from the default values.
Programming Sections are accessed through the keypad or DLS 5.
NOTE: The Keypad is unable to view any sections that uses ASCII Characters.
System Options
[001] Ethernet IP Address
Default (000.000.000.000)
Enter the IP address of the Communicator. Ensure that the IP address is unique to your Communi-
cator on the local network. Format is 4 fields, each field is a 3 digit decimal number. Valid range:
000-255. If an IP address is programmed in this Section, the unit will operate with Static IP
(DHCP disabled). Sections [002] and [003] must also be programmed when using Static IP
addresses.
NOTE: Default for this Section is Dynamic Host Configuration Protocol (DHCP) enabled. When
enabled, the DHCP Server will set values for: IP Address [001], Subnet Mask [002], and Gateway
[003]. Programming an IP address in this Section will disable DHCP (Static IP).
[002] Ethernet IP Subnet Mask
Default (255.255.255.000)
Enter the Ethernet IP Subnet Mask of the Communicator. Format is 4 fields, each field is 3 digits.
Valid range: 000-255.
NOTE: If DHCP is enabled, the DHCP Server will assign the subnet mask for this Section and the
programmed value will be ignored.
[003] Ethernet Gateway IP Address
Default (000.000.000.000)
Enter the Ethernet Gateway IP address of the Communicator. The gateway IP address is required
when a router is used on the local network to reach the destination IP address specified in Section
[001]. Format is 4 fields, each field is a 3 digit decimal number. Valid range: 000-255.
NOTE: If DHCP is enabled, the DHCP Server will assign the Gateway IP address for this Section
and the programmed value will be ignored.
[004] Receiver Supervision Interval
Default (0087/135)
When receiver supervision is enabled (ON) in Section [005] Toggle Option [3], the unit sends
heartbeats to Ethernet Receiver 1 or Cellular Receiver 1 to test the communications path. Use this
Section to set the interval time (in seconds) when heartbeats will be sent to the receivers. Valid
range 000A-FFFF seconds. If the programmed value is less than (000A/10) seconds, supervision is
disabled.
[005] System Toggle Options
[1] Ethernet Receiver 1 Supervised
Default (OFF)
TL2603G/TL260 only
ON: Ethernet Receiver 1 will be supervised and heartbeats will be sent to Ethernet Receiver 1 based on
the supervision interval programmed in Section [004].
OFF: Ethernet Receiver 1 will not be supervised. When disabled, heartbeat 1 is sent to the Ethernet
receiver once every hour, regardless of supervision type (heartbeat 1 or 2). The heartbeat is resent every
5 seconds until ACK. If no event or heartbeat ACK is received after (Receiver Supervision Interval + 75
seconds), Supervisory trouble is indicated.
NOTE: Ethernet Receiver 2 can not be supervised.
/C
ELLULAR
3G Alarm Communicator Installation Manual
P
ROGRAMMING
14
O
PTIONS
Hide quick links:
Advertisement
Table of Contents
