Table of Contents
Advertisement
U‐Hub
If the total does not match what Vu‐Net has discovered the numbers will be flagged in red. Click next and you will see a new
window showing the array or arrays; ‐
If you have more than one array the first step is to use the 'ALL ON' button which will illuminate all the LED badges on the array
to check that the Vu‐Net arrays match the physical deployment. If there are any errors the cabinets can be dragged and dropped
to the correct positions or array. If you only have one array it is still worth flashing all LED's to see the look on the faces of the
lighting technicians when they see LED lighting over which they have no control...
Next click the 'BY ONE' button. This will flash the LEDs in sequence from top to bottom. As the U‐Net network is bi‐directional it
is entirely possible that the arrays could have been discovered starting with what is actually the last cabinet in the array. If this
has happened you will see the LEDs on the actual cabinets flashing from bottom to top and you MUST click 'REVERSE ORDER' to
get it flashing the right way up. This is essential so that Vu‐Net knows that the array is orientated the right way, failure to do this
U‐Hub User Guide V1.0
USER GUIDE
39
Advertisement
Table of Contents
