U-Hub Network Connections - Martin Audio U-Hub User Manual

U‐Hub
U‐Hub Network Connections
U‐Hub features a standard RJ45 Ethernet port on the rear panel using a Neutrik Ethercon connector. This is wired using the
standard Ethernet wiring protocol so any off the shelf CAT5E or better network cable can be used to connect the U‐Hub to your
Ethernet network.
There are two front panel mounted U‐Net ports for connection to the U‐Net enabled devices in your system. These use ODU
connectors to the LEMO high speed data series pattern. Wiring configuration is as follows; ‐
The two pairs of linked ODU connectors are wired as shown in the block diagram. Pins 1, 2, 3 & 6 are linked together, pins 4 and
5 on the link out connectors have the audio signal from the corresponding audio input.
The same cable wiring configuration should be used for all network connections.
U‐Hub User Guide V1.0
USER GUIDE
14