Table of Contents
Advertisement
U‐Hub
Allows you to adjust the system diagram size to suit the complexity of the system on your PC display. The '‐' and '+' buttons will
decrease or increase the zoom in increments of 25%. Alternatively, you can use the drop‐down box to select either 10%, 25%,
50%, 100%, 125%, 150%, 200%, 300%, 400%, 600% or 800%. Particularly useful are 'Page' which will zoom to the maximum size
that the page will allow, 'Width' which will zoom to the maximum width of the diagram and 'Height' which will maximise the size
to fit the height of the diagram.
Mute is essentially an "emergency" function if something is causing severe noise through the system you can click on the mute
button; ‐
This will bring up the following window; ‐
As you can see it is a very drastic measure which will shut down the entire system which is why it should be considered as an
emergency measure only and not an everyday means for muting the system. If you are sure you wish to proceed you can select
'Yes' if not click on 'No' and the window will disappear, the audio will remain routed. This function mutes every input and output
on connected Merlins and every zone on all arrays. Once used there is no global un‐mute, all Merlins and arrays will have to be
individually un‐muted. Note that Show Modes does not change operation of the System Mute, the confirmation window will
always appear.
Our advice is never to leave a system muted within Vu‐Net, always use a mute that can be defeated manually such as a Merlin
output. If a system has been muted within Vu‐Net and for some reason you lose network connectivity you will be unable to un‐
mute and will have an unusable system!
System Disconnect
This will disconnect the project from the hardware in the system. A Window will pop up giving you a selection of options; ‐
As you can see, once you are disconnected from the system you are unable to make any changes to the project, this is to ensure
compatibility and accurate synchronisation when you reconnect. You have the option to reconnect straight from the window or
can close the project with or without saving. Finally, you can minimise the project. This is particularly useful if you have
disconnected to switch from a Wi‐Fi to a hard‐wired connection, having minimised to can access the PC network setting to make
the switch to a cable Ethernet connection.
U‐Hub User Guide V1.0
USER GUIDE
31
Advertisement
Table of Contents
