Table of Contents
Advertisement
U‐Hub
Rear Panel
1. Power Inlet‐ The unit should be connected to a suitable mains electricity supply using a
standard IEC power lead. The device has a switch mode power supply that is capable of
operating with a nominal mains voltage of 100V to 230V, 50/60Hz without re‐configuration.
The IEC connector should be compatible with the retention clip so it can be secured with the
clip to ensure the connector cannot accidentally disconnect.
2. Main Fuse‐ This should be fitted with an anti‐surge (T)fuse rated at 1 amp.
3. Ethernet‐ Neutrik Ethercon allowing an ethernet connection using wither a standard CAT5E
connector or an Ethercon cable.
4. Analogue / AES EBU Audio Inputs‐ Carries audio feed to the three ODU audio outputs
combined with the U‐Net network.
U‐Hub User Guide V1.0
USER GUIDE
16
Advertisement
Table of Contents
