Specifying An Operating Mode For A Service Module - HP 10500 Series Configuration Manual

When the temperature drops below the low-temperature threshold or reaches the high-temperature
warning threshold, the device performs the following operations:
Logs the event.
•
Sends a log message.
•
Sends a trap.
•
When the temperature reaches the high-temperature alarming threshold, the device performs the
following operations:
Logs the event.
•
• Repeatedly sends log messages.
Repeatedly sends traps.
•
Sets the LEDs on the device panel.
•
To configure the temperature alarm thresholds:
Step
1. Enter system view.
2. Configure the temperature
alarm thresholds.

Specifying an operating mode for a service module

Different types of service modules support different operating modes and provide different amounts of
MAC address table space and routing table space. For information about supported service module
types and operating modes and the table sizes, see
modes for service modules to meet the network requirements.
Table 16 Service module operating modes
Operating mode
normal
bridging
routing
Command
system-view
•
In standalone mode:
temperature-limit slot
slot-number { hotspot | inflow
| outflow } sensor-number
lowlimit warninglimit
[ alarmlimit ]
•
In IRF mode:
temperature-limit chassis
chassis-number slot
slot-number { hotspot | inflow
| outflow } sensor-number
lowlimit warninglimit
[ alarmlimit ]
Feature highlights
Uses the default MAC address table and
routing table.
Increases the MAC address table size to
provide higher Layer 2 packet
forwarding performance.
Increases the IPv4 routing table size to
provide higher Layer 3 packet
forwarding performance.
231
Remarks
N/A
To view the default thresholds, use
the undo form of the command to
restore the default and execute the
display environment command.
The high-temperature alarming
threshold must be higher than the
high-temperature warning
threshold. The high-temperature
warning threshold must be higher
than the low-temperature
threshold.
Table 16 and Table 17. You can specify operating
Recommended application scenario
Common networks.
A large MAC address table is required.
A large IPv4 routing table is required.