Cappuccino Maker - Wega WEGACONCEPT Series Instruction Manual

Regeneration notifi cation
If the function has been enabled during program-
ming, the system measures the amount of water
used by the machine and signals on the display
(with the fl ashing phrase "WATER SOFTENER REGEN-
ERATION") the need for regeneration when the set
amount has been exceeded.
Once the regeneration has been carried out, the
counter must be reset.
i
To reset the litres count, contact specialised
personnel.

14.2 Cappuccino maker

• Put the suction tube inside the milk;
• place the jug under the spout of the cappuccino
maker;
• open the steam tap, when the desired amount is
reached close the steam tap;
• pour the foamed milk into the cups with coff ee.
To obtain the dispensing of warm milk without
foam, lift the tab (Z) upwards. For better re-
i
sults, we suggest not to dispense directly into
the coff ee cup, but into a jug or pot, and to then
pour the foamed milk on the coff ee. Be sure the
cappuccino maker is kept clean as described in
the chapter "Cleaning".
User manual
Cleaning
Use special care in cleaning the cappuccino
maker, following the procedures indicated below:
• perform a fi rst washing by immerging the suc-
tion tube in water and run a delivery for a few
seconds;
• turn the rotating body (
sure of milk outlet duct);
• holding the milk suction tube in the air, dispense
steam (cappuccino maker dry run);
• wait about 20 seconds to allow for internal clean-
ing and sterilisation of the cappuccino maker;
• close the steam and put the rotating body back
in position A;
• if the air intake hole (
with a pin.
X
It is advisable to clean the cappuccino maker
!
after each period of continued use so as to
avoid malfunctions and to ensure a high rate
of hygiene in the system.
Z
Wegaconcept
X) 90° to position B (clo-
Y) is blocked, clear it gently
Pos.A Pos.B
Y
23