Table of Contents
Advertisement
11.1 Automatic heating and foaming
Proceed as follows:
•
Immerge the tips of the autosteamer (
the beverage;
•
press the
or
ing on the dose of milk in the jug;
•
wait until the dispensing is fin-
ished;
•
when the dispensing has fi nished,
the milk will be foamed and heated
to the preset temperature.
•
To stop dispensing ahead of time, press the same
key;
•
to prolong the dispensing of steam, use the key
"Manual steam"
To increase or decrease the consistency of the
foam, slightly adjust the special regulator (A). Turn-
ing it clockwise will decrease the consistency, while
turning it counterclockwise will increase it.
Always proceed by performing slight adjust-
ments.
The autosteamer foaming is factory-adjusted,
!
in the testing phase of the machine. Therefore,
it is recommended to modify the adjustment
only if strictly necessary.
User manual
13) into
13
key, depend-
.
11.2 Automatic heating
Proceed as follows:
•
Immerge the tips of the autosteamer (
the beverage;
•
press the
key;
•
wait until the dispensing is fi nished;
•
once the dispensing has fi nished, the milk will
be heated to the programmed temperature, but
not foamed.
•
To stop dispensing in advance, press the same
key;
•
to prolong the dispensing of steam, use the key
"Manual steam"
11.3 Manual heating and foaming
This control allows the user to use the auto-
steamer nozzle to heat and at the same time foam
the milk, letting him use it manually.
Proceed as follows:
•
Immerge the tips of the autosteamer (
the beverage;
•
press the
key;
•
To stop dispensing, press the same key again.
A
11.4 Automatic cleaning
After 120 minutes of idle time the automatic
cleaning of the nozzle starts, lasting 15 seconds.
The message will appear on the display: "STEAM
CLEANING CYCLE"
A minimum amount of steam will exit the nozzle.
Wegaconcept
13) into
.
13) into
17
Hide quick links:
Advertisement
Table of Contents
