Removing And Installing Metal Cutting; Attachment; Adjusting Trimmer For User; Using With Stihl Ar Battery - Stihl FSA 130 Instruction Manual

7 Adjusting Trimmer for User

6.5

Removing and Installing Metal Cutting

Attachment

6.5.1 Mounting Metal Cutting Attachment
► Switch off the trimmer and pull the connecting cable plug
out of the socket.
► Place the thrust plate (5) on the shaft (6) so that its smaller
diameter faces up.
► Place the metal cutting attachment (4) on the thrust
plate (5). If you are fitting a circular saw blade or a grass
cutting blade with more than 4 cutting edges: Its cutting
edges must face in the same direction as the arrow on the
deflector.
► Place the thrust washer (3) on the metal cutting
attachment so that its raised side faces up.
► Place the rider plate (2) on the thrust washer (3) so that its
closed side faces up.
0458-726-9921-A
► Insert the stop pin (7) in the bore as far as stop and hold
it depressed.
► Rotate the metal cutting attachment (4) clockwise until the
stop pin (7) engages in position.
The shaft is now blocked.
► Fit the nut (1) counterclockwise and tighten it down firmly.
► Remove the stop pin (7).
1
6.5.2
► Switch off the trimmer and pull the connecting cable plug
2
out of the socket.
► Insert the stop pin in the bore as far as stop and hold it
3
depressed.
► Rotate the metal cutting attachment clockwise until the
stop pin engages in position.
4
The shaft is now blocked.
► Unscrew the mounting nut clockwise.
► Remove the rider plate, thrust washer, metal cutting
attachment and thrust plate.
► Remove stop pin.
5
6
7 Adjusting Trimmer for User
7.1
7
7.1.1
The connecting cable can be fitted and adjusted to suit the
user's size and the application.
Removing the Metal Cutting Attachment

Using with STIHL AR Battery

Fitting and Adjusting the Connecting Cable
English
49